Audi Q7 Owners & Service Manuals

Audi Q7: Speed warning system

Audi Q7 (4M) 2016-2024 Owner's Manual / Assist systems / Driving information / Speed warning system

Description

Applies to: vehicles with speed warning system

The speed warning system helps the driver to stay below a specified maximum speed. A warning threshold can be set in the MMI for this purpose.

Once the speed slightly exceeds the stored threshold, the speed warning system will alert the driver with an indicator in the instrument cluster and a warning tone. Once the speed drops below the stored maximum speed, the indicator will turn off.

Setting a threshold is recommended if you would like to be reminded when you reach a certain maximum speed. Situations where you may want to do so include driving in a country with a general speed limit or if there is a specified maximum speed for winter tires.

Tips

Regardless of the speed warning system, you should always monitor your speed using the speedometer and make sure you are adhering to the legal speed limit.

Setting the warning threshold

Applies to: vehicles with speed warning system

  • Applies to MMI: Select on the home screen: VEHICLE > Driver assistance > () > Speed warning.

Messages

Applies to: vehicles with speed warning system

The following messages may appear depending on the vehicle equipment:

Manually set speed limit XX mph (km/h) exceeded

The stored speed was exceeded.

    READ NEXT:

     Camera-based traffic sign recognition

    Description Applies to: vehicles with camera-based traffic sign recognition Fig. 101 Instrument cluster: traffic sign recognition The traffic sign recognition shows the traffic signs detected by t

     Traffic light information

    Description Applies to: vehicles with traffic light information Fig. 102 Instrument cluster: traffic light information display The traffic light information gives you a speed recommendation in ord

     Lap timer

    Introduction Applies to: vehicles with lap timer You can record and evaluate lap times with the lap timer. You can operate the lap timer using the multifunction steering wheel. Opening the lap timer

    SEE MORE:

     Component Location Overview - Gaskets

    Component Location Overview - Gaskets, 0DB and 0D2 1 - Right Flange Shaft Removing and installing. Refer to → Chapter "Right Seal, Replacing". Final drive 0DB: the right and left flange shaft are identical Final drive 0D2: -Arrow a- shaft diameter approximately 40 mm 2 

     Front Bumper Cover, Removing and Installing

    To complete the procedure, a second technician is required to be at the following position. Depending on the equipment version, the following additional work must be performed. Special tools and workshop equipment required Hose Clamps - Up To 25 mm -3094- Engine Bung Set -VAS6122- Remov

    © 2019-2024 Copyright www.a-q7.com