Battery General Information
To guarantee a long service life, the Battery -A- must be
checked, serviced and maintained as described in this manual.
The Battery -A- supplies the power to start the eng
Battery, Checking, Vehicles with Battery Monitoring Control Module J367
or Energy Management Control Module J644 and Data Bus On Board Diagnostic
Interface J533
In certain model series the followi
SEE MORE:
Special tools and workshop equipment
required
Torque Wrench 1331 5-50Nm -VAG1331-
Removing
Note
During installation, all cable ties must be installed at the
same location.
Before starting work:
- Versions with coil springs: determine the curb weight
position. Refer to
→ Ch
Overview - Balance Shaft
1 - Balance Shaft
Removing and installing. Refer to
→ Chapter "Balance Shaft, Removing and Installing".
2 - Bolt
40 Nm +90º
Replace after removing
For loosening and tightening, use the Locating Pins -T40116- as a
counterholder
3 -&
