Audi Q7 Owners & Service Manuals

Audi Q7: Engine oil

If the engine oil level too low

If you need to add engine oil, use an oil that is listed on the sticker. The sticker is located at the front of the engine compartment fig. 164. When using the engine oil listed on the sticker, you can adjust the oil level as often as needed.

If engine oil that meets the recommended specification is not available, in an emergency you may add a maximum of 0.5 quart (0.5 liter) of ACEA C3 or API SN engine oil one time until the next oil change.

Audi recommends having the oil changed by an authorized Audi dealer or authorized Audi Service Facility.

Note

Audi recommends using approved engine oil that meets the respective VW standard. Using engine oils which do not meet these quality standards can cause damage to the engine.

Tips

Audi recommends using engine oils provided by Audi Genuine Parts.

Messages

The following messages may appear depending on the vehicle equipment:

Turn off engine. Oil pressure too low

Stop driving and switch the engine off. Check the engine oil level.

  • If the engine oil level is too low, add engine oil. Only continue driving once the indicator light turns off.
  • If the engine oil level is correct and the indicator light still turns on, turn the engine off and do not continue driving. See an authorized Audi dealer or authorized Audi Service Facility for assistance.

Applies to: vehicles with oil level warning

Please add oil immediately.

Stop driving and switch the engine off. Check the engine oil level and add engine oil immediately.

Add max. x qt (x l) oil. You can continue driving

Add the amount of oil shown immediately.

Please reduce oil level

There is too much oil in the engine and there is a risk of damaging the catalytic converter or engine.

Drive to an authorized Audi dealer or authorized Audi Service Facility immediately to have engine oil extracted if necessary. Avoid high engine speeds, full acceleration, and heavy engine loads.

Oil level sensor: oil change necessary. Please contact Service

Fuel has entered the engine oil. This will cause the engine oil level to rise slowly and the engine oil quality to decrease. Do not extract engine oil to reduce the level, because this will increase the risk of engine damage. Drive to an authorized Audi dealer or authorized Audi Service Facility immediately to have engine oil extracted.

Oil level system: malfunction! Please contact Service

The sensor that checks the engine oil level has malfunctioned. Drive immediately to an authorized Audi dealer or authorized Audi Service Facility to have the malfunction repaired.

Oil pressure sensor: malfunction! Please contact Service

The sensor that checks the engine oil pressure has malfunctioned. Drive immediately to an authorized Audi dealer or authorized Audi Service Facility to have the malfunction repaired.

Please drive to warm up engine

Especially low outside temperatures are a main reason why fuel may get into the engine oil. The fuel can only evaporate from the engine oil if the engine oil temperature is high enough.

Drive in the "S" gear.

Drive the engine at higher RPMs while avoiding full acceleration.

You should drive for at least 30 minutes. The indicator light may not turn off during this time.

Repeat the steps that are described at any time.

Have an authorized Audi dealer or authorized Audi Service Facility repair the malfunction if the indicator light does not turn off after a few drives.

WARNING

When the message Please drive to warm up engine appears, adjust your speed according to the weather, road, terrain, and traffic conditions. You should never disobey the traffic laws applicable in the country in which you are driving in order to follow driving recommendations.

Tips

The oil pressure warning is not an oil level indicator. Always check the oil level regularly.

Checking the engine oil level

The engine oil level can be checked in the MMI.

Observe the safety precautions General information.

  • Park the vehicle on a level surface.
  • Shut the engine off when it is warm.
  • Switch only the ignition back on.
  • Wait approximately five minutes so that the engine oil can flow back into the engine oil pan.
  • Applies to MMI: Select on the home screen: VEHICLE
  • Settings & Service > Oil level.
  • Read the oil level in the display. Add engine oil if the bar in the oil level indicator is just below "min".

Note

If the engine oil level is too low or too high, there is a risk of engine damage.

Tips

The oil level indicator in the display is only an informational display. If the oil level is too low, a minimum oil warning appears in the instrument cluster. Add oil and close the hood.

The current oil level will be displayed on the MMI the next time the ignition is switched on.

Tips

The engine oil consumption may be up to 0.5 quart/600 miles (0.5 liter/1,000 km), depending on driving style and operating conditions.

Consumption may be higher during the first 3,000 miles (5,000 km). The engine oil level must be checked regularly. It is best to check each time you refuel your vehicle and before long drives.

  • Because of the lubrication and cooling of the engine, combustion engines consume oil. The oil consumption varies depending on the engine and may change during the service life of the engine. Engines generally consume more oil at the beginning during the break-in period. Then oil consumption stabilizes after the break-in period.
  • Under normal conditions, oil consumption depends on the quality and viscosity of the oil, the engine RPM, the climate conditions, and the road conditions. The dilution of oil from condensation or fuel residue as well as the age of the oil also play a role. Because engine wear increases with mileage, oil consumption will increase again over time until it may be necessary to replace worn components.
  • Because all these variables play a role, it is not possible to define an oil consumption standard. Therefore, the oil level must be checked regularly.
  • If you believe that your engine has increased its oil consumption, contact an authorized Audi dealer or authorized Audi Service Facility to determine the cause. Please note that an exact oil consumption measurement must be done with the necessary care and accuracy and may take time. An authorized Audi dealer or authorized Audi Service Facility is trained in accurately measuring the oil consumption.
  • You can find information on engine oil and engine oil capacities for the USA at www.audiusa.com/help/maintenance, or for Canada at www.audi.ca/ca/web/en/ customer-area/care-and-maintenance/ audi-service-schedules.html, or call 800-822-2834.

    READ NEXT:

     Adding engine oil

    Fig. 165 Engine compartment: engine oil filling opening cover (example) Observe the safety precautions > General information. Turn the engine off Open the hood Unscrew the cap for the eng

     Cooling system

    Coolant The engine cooling system is filled with a mixture of purified water and coolant additive at the factory. This coolant must not be not changed. The coolant level is monitored using the indi

     Brake fluid

    Fig. 167 Motor compartment: cap on brake fluid reservoir Observe the safety precautions, General information. Checking the brake fluid level The brake fluid reservoir is located under a cover on the

    SEE MORE:

     Exterior Door Handle Lamps

    Overview - Exterior Door Handle Lamps 1 - Exterior Door Handle Illumination Bulb Front exterior door handle Left Front Exterior Door Handle Illumination Bulb -L162- Right Front Exterior Door Handle Illumination Bulb -L163- Removing and installing. Refer to → Chapter "Left and

     Accelerator Mechanism

    Overview - Accelerator Pedal Module 1 - Accelerator Pedal Module With Accelerator Pedal Position Sensor -G79- and Accelerator Pedal Position Sensor 2 -G185-   2.5 mbar (0.036 psi) Check using the Vehicle Diagnostic Tester. Refer to → Chapter "Accelerator Pedal Position

    © 2019-2024 Copyright www.a-q7.com