Audi Q7: Voice Recognition System
General Information - Voice Recognition System
The voice recognition system enables voice operation of the telephone, Infotainment and navigation system.
Functions can be conveniently operated by voice commands. System is activated via the PTT button in the multi-function steering wheel.
The voice recognition system is integrated in the Information Electronics Control Module 1 -J794-.
Fault Finding is performed using the "Guided Fault Finding" on the Vehicle Diagnostic Tester.
Voice Recognition System, Removing and Installing
The voice recognition system is part of the Information Electronics Control Module 1 -J794- inside the glove compartment. It cannot be replaced alone.
If it is faulty, then the Information Electronics Control Module 1 -J794- must be replaced.
Note
If replacing the control module, select the "Replace control module" function for the corresponding control module on the Vehicle Diagnostic Tester.
Removing
- Turn off the ignition and all electrical equipment and remove the ignition key.
- Remove the Information Electronics Control Module 1 -J794-. Refer to → Chapter "Information Electronics Control Module 1 -J794-, Removing and Installing".
Installing
- Install the Information Electronics Control Module 1 -J794-. Refer to → Chapter "Information Electronics Control Module 1 -J794-, Removing and Installing".
Perform the following function test:
- Switch on the Radio -R-.
- Press the PTT button on the multifunction steering wheel briefly.
A "Ping" tone soands, the speech input system is active.
- Say the command "Help".
When the Radio -R- is active, the voice recognition system responds with "Commands for the radio are...".
Depending on the equipment, other functions can be selected:
- If a telephone is installed, say "telephone".
The voice recognition system switches to the telephone mode.
- Press the PTT button for 1 second.
The voice recognition system responds with "Cancel" and is deactivated.
