Audi Q7: Body Exterior

 Wire Junction, Removing and Installing

Wire Junction -TV1-, Removing and Installing, Vehicles without High-Voltage System Removing - Disconnect the ground cable from the battery when the ignition is switched off. Refer to → Chapter "Battery, Disconnecting and Connecting". - Remove the front sill panel. Refer to →&n

 Rear Lid Seal, Removing and Installing

Removing - Remove the rear lid seal from the body flange. Installing Install in reverse order of removal and note the following: - Install the rear lid seal on the body flange in the sequence: -1, 2 and 3-. - Align the mark -A- on the rear lid seal to the center roof frame seal hole