Audi Q7: Panoramic glass roof
Operating the panoramic glass roof and
roof sunshade
Applies to: vehicles with panoramic glass roof and roof sunshade
Fig. 33 Headliner: panoramic glass roof and sunshade buttons
The control buttons are equipped with a twostage
function.
Operating the roof sunshade
The roof sunshade cannot be closed completely if
the roof is open.
- Opening and closing the sunshade: push the
switch in the headliner (3) briefly toward the
rear or forward to the second level.
- Partially opening the sunshade: press the
switch to the first level until the sunshade
reaches the desired position.
Operating the roof
- Tilting the roof: press the
switch in the
headliner briefly up to the second level (1).
- Closing the tilted roof: pull the
switch down
briefly to the second level.
- Opening the roof: slide the
switch back
briefly twice in a row to the second level (2).
- Closing the opened roof: push the
switch
forward briefly to the second level.
- Opening or closing partially: slide the
switch to the first level and hold it there until
the roof reaches the desired position.
Quick opening
You can also open the roof and roof sunshade in
one movement.
- Push the
switch back
briefly to the second
level (2) twice in a row.
Roof emergency closing
If an object is detected when closing, the roof will
open again automatically. In this case, you can
then close it with the power emergency closing
function.
- Within five seconds after the sunroof opens automatically,
pull the applicable button until the
roof is closed.
WARNING
- Observe the safety precautions.
- To reduce the risk of injury, always pay attention
when closing the roof. Always switch
the ignition off and take the key with you
when leaving the vehicle.
Note
- Always close the roof when you leave the vehicle
and when there is precipitation to reduce
the risk of damage to the interior equipment,
particularly the electronic equipment.
Tips
- After switching off the ignition, the roof and
sunshades can still be operated for several
minutes as long as neither of the front
doors have been opened.
- It is not possible to open the roof when temperatures
are too low.
READ NEXT:
Description
Applies to: vehicles with garage door opener
With the garage door opener, you can activate
systems such as the garage doors, security systems
or house lights from inside your vehicle.
T
Switching the lights on and off
Fig. 34 Instrument panel: light button module
Light switch
Press and hold (1) until the desired light function
is selected. The selected function is displayed
bri
SEE MORE:
The valve insert must be replaced with every tire change.
Metal valve and wheel electronics can be reused.
- Let air out of tire by removing the valve insert.
Note
Be careful not to scratch off the glued- on wheel trim on
these rims.
The surface of the wheel trim is very sensitive.
Valve Stem Seals, Removing and Installing, Cylinder Head Installed
Special tools and workshop equipment
required
Spark Plug Removal Tool -3122B-
Puller - Valve Seal -3364-
Seal Installer - Valve Stem -3365-
Valve Keeper Tool Kit -VAS5161A- with the Valve Cotter Tool
Kit - Guide Plate 19c -VAS