1 - Transmission
2 - Hose Clamp
Replacing
3 - Driveshaft
Removing and installing. Refer to
→ Chapter "Driveshaft, Removing and Installing".
Removing and in
Special tools and workshop equipment
required
Flanging Tool -T40261-
Hose Clamp -23 to 35 mm Diameter-
Caution
This procedure contains mandatory replaceable parts.
Refer to component ov
Special tools and workshop equipment
required
Hose Clamps - Up To 25 mm -3094-
Engine Bung Set -VAS6122-
Container of the Coolant Collection System -VAS5014- or the
Shop Crane - Drip Tray -VAS6208-
Hose Clip Pliers -VAS6362-
Caution
This procedure contains mandatory replaceable part
Preparation
You should only perform the steps that follow if
you have the necessary tools and technical expertise.
If the engine does not start because the vehicle
battery is drained, you can jump start your vehicle
using another vehicle. Jump start cables are
needed to do this.
Both vehicle batter
Overview - Driveshaft
