Overview - Coolant Pump/Coolant Thermostat
Coolant Pump/Coolant Thermostat
1 - Bolt
Tightening specification. Refer to -item 9-
Not available separately, one unit with -3-
2 -&nbs
Coolant Recirculation Pump -V50-, Removing and Installing
Special tools and workshop equipment
required
Hose Clamps - Up To 25 mm -3094-
Hose Clip Pliers -VAS6340-
Removing
- Remove the air
Note
Both the selector lever handle and the selector lever boot
are removed.
Special tools and workshop equipment
required
Trim Removal Wedge -3409-
Torque Wrench 1410 -VAG1410-
Removing
Ignition switched off.
- Remove the selector lever handle upper section
-1- upward in direc
Mode 07 makes it possible to check emissions-related faults
which appeared during the current or last driving cycle (pending
DTCs).
A pending DTC is saved the first time a fault is detected
(output via Mode 07).
- If the fault is detected again by the end of the following
driving cycle, a c